Morris CX 8105, Operator'S Manual, Page: 105 / 182

Monitor
CX 8105 - Ground Drive December 2016 6-19
Monitor Settings - Continued
PP400 - Continued
Speed Calibration - Continued
2. Select “Speed Settings” under the “Settings Menu”.
3. Then select “Speed Calibration”.
Use the Up/Down keys to select “Continue Calibration”
at which point the monitor will request “Start Driving”.
4. Drive the marked distance and the monitor will count
the number of pulses.
5. When the distance has been travelled, stop, press
the SELECT key to stop the pulse counting. This
will “Exit and Save” the new pulse count under the
“Speed Settings” menu.
6. The new value will now be displayed under “Wheel
Pulses Per 400 Feet” (PP400).
7. Select “Exit and Save” to exit “Speed Settings” and
return to the main menu.
Note: The monitor can accept PP400 values from
50 to 9999. Therefore, if the new count is less
than 50, the existing count is not replaced.
The monitor will state “Pulses Too Low” and
display options to “Continue Driving” or
“Cancel Calibration”.
1
2
3
4
5
6