Morita Lubrina 2, Instructions For Use Manual, Page: 23 / 48

21
Instructions for Use 2019-01-16
7.1 Operating, Transport and Storage Environments
7 Usage
Operating Environments:
Temperature: +10°C to +40°C (+50°F to +104°F)
Humidity: 30% to 75% (without condensation)
Atmospheric Pressure: 70 kPa to 106 kPa
■ Do not expose the device to direct sunlight for an extended period of time.
■ If the device has not been used for some time, make sure it works properly before using it again.
Transport and Storage Environments:
Temperature: -10°C to +50°C (+14°F to +122°F)
Humidity: 10% to 85% (without condensation)
Atmospheric Pressure: 70 kPa to 106 kPa
■ Do not transport or store the device with spray cans installed.
7.2 Maintenance Categories
Maintenance categories for the Lubrina 2 are shown in the table below.
p. 26 “7.3.4 Switching Maintenance Mode”
Maintenance
Category
Purpose
Applications
p.9
Total Operating
Time
Basic Operations
Air Turbine
Handpiece
Micromotor
Attachment
Chuck Lubrication
(daily use)
Chuck maintenance performed
before handpiece body lubrication.
Approx. 4 sec
p. 22
“7.3.2 Chuck Lubrication”
Handpiece Body
Lubrication
(daily use)
Mode 1
Approx. 20 sec/
handpiece
p. 23
“7.3.3 Handpiece Body Lubri-
cation”
Mode 2
Approx. 40 sec/
handpiece
Flushing
(as necessary)
When black colored oil comes
from the handpiece.
Approx. 80 sec/
handpiece
p. 27
“7.4.2 Flushing Mode”
Air Blow
(as necessary)
To remove water and excess oil
inside the handpiece.
Approx. 30 sec/
handpiece
p. 27
“7.4.1 Air Blow Mode”