F-6 PREPARATION BEFORE STARTING MASS PRODUCTION
4
PROGRAM CHECK
After creating a program, it is necessary to check it for the purposes of debugging (to find program
errors, wrong tool offset data, interference, etc.).
4-1
Preparations for Checking a Program
This section describes the preparatory steps for checking a program.
1)
Shape the soft jaws appropriately for the material
and shape of the workpiece, chucking method
(inside chucking or outside chucking), etc.
It is necessary to shape the soft jaws so that the
workpiece can be clamped in the chuck stably.
Chapter C "SHAPING SOFT JAWS FOR
2)
Mount the tools and the workpiece in the machine
by moving the axes and indexing the turret head
manually.
For center-work operation, move the tailstock
spindle OUT to hold the workpiece.
"TOOLING SYSTEM" in the
MAINTENANCE INFORMATION
3)
Set the workpiece zero point.
Chapter E "SETTING OF COORDINATE
4)
Input the created program to the NC memory using
the keyboard on the operation panel or the external
I/O device.
NOTE
Z
X
