SETTING OF COORDINATE SYSTEM E-53
9-6
Parameters
The in-machine tool presetter function uses the following parameters. The settings of these
parameters do not need to be changed.
The symbol
in the table denotes the initial setting at shipment.
For some parameters, their addresses differ depending on machine models. For PC
parameters, refer to the ladder diagram.
Contact Mori Seiki when parameter settings must be changed. Mori Seiki is not
responsible for accidents that occur as a result of changing of parameter settings
without consultation.
1.
NC parameter
Data number . . . . . . 1202
Data number . . . . . . 5004
Data number . . . . . . 5005
7
6
5
4
3
2
1
0
WZS
Data Type
Bit Type
WZS
0
Direction of the offset data set to "COMMON" on the WORK COORDINATES screen:
Opposite to work shift
1
Direction of the offset data set to "COMMON" on the WORK COORDINATES screen:
Same as work shift
7
6
5
4
3
2
1
0
TS1
Data Type
Bit Type
TS1
0
Other than detachable tool presetter Type II
1
Detachable tool presetter Type II
7
6
5
4
3
2
1
0
QNI
Data Type
Bit Type
QNI
0
In the offset data write mode, the tool offset number is not selected automatically.
1
In the offset data write mode, the tool offset number is selected automatically.
CAUTION
