E-30 SETTING OF COORDINATE SYSTEM
7-1
Setting the Work Coordinate System
This section describes the procedures for setting the work coordinate system using the data entry
keys and the
[MEASURE]
soft-key.
Make sure to set "0" at the DATA (coordinate system shift data) column of the work
coordinate system NO. "00 (EXT)" on the WORK COORDINATES screen.
If the work coordinate system shift data is set for NO. "00 (EXT)", the work coordinate
system is shifted in the same direction disregarding of the spindle (spindle 1 and
spindle 2) to be used, which causes the turret to interfere with the workpiece resulting
in machine damage.
Among the coordinate system numbers from 01 (G54) to 06 (G59), set those used for
spindle 1 and those for spindle 2 on the WORK COORDINATES screen beforehand.
7-1-1
Setting the Work Coordinate System Using the Data Entry Keys
1)
Press the HEAD CHANGE switch
(head 1) or
(head 2) to select the required turret.
2)
Display the WORK OFFSET screen.
a)
Press the function selection key
(OFFSET).
b)
Press the
[WORK]
soft-key.
The WORK OFFSET screen is displayed.
3)
Move the cursor to the number (G54 - G59) of the
work coordinate system where the data should be
input.
CAUTION
NOTE
2
1
HEAD CHANGE
1
2
NETWORK
POS
PROG
SYSTEM
MESSAGE
SETTING
OFFSET
CAPS
CAPS
OFFSET
GEOM.
WEAR
SET UP
WORK
MEASURE
(+)
INPUT
1
F
10
F
2
F
3
F
4
F
5
F
6
F
7
F
8
F
9
F
