D-10 PROGRAM EDITING
3-3
Word Search
A word search operation is required when editing a program. First, the program to be edited is
called by the program number search operation and, then, the word to be edited is located by the
word search operation.
The following three methods are used for the word search operation:
1.
Searching for a word with the cursor control keys
2.
Searching for a word with the page selection keys
3.
Searching for a word using the data entry keys and the soft-keys
<Cautions on word search using data entry keys and soft-keys>
1.
If the searched word appears more than once in the program, the first occurrence of
the word located after the current cursor position is searched for.
2.
Enter the word to be searched for exactly as it appears in the program.
For example, "M3" cannot be used to search for "M03".
3.
Press the
[SEARCH
]
soft-key or the cursor control key
to search for a word
located before the current cursor position.
4.
If the searched word does not exist, the message "STRING NOT FOUND" is
displayed.
NOTE
