B-100 MANUAL OPERATION
16
SETTING AND OPERATION OF PARTS CATCHER (S TYPE)
The procedure used for setting the parts catcher positions and in/out operation is explained below.
The parts catcher is used to discharge a machined workpiece.
Two kinds of parts catcher specifications are available. They are bucket specification and hand
specification.
16-1
Setting Parts Catcher Positions
Set the parts catcher positions by following the procedure indicated below.
The position data is set in the coordinate values (unit: 0.001 mm) in reference to the home position
(parts catcher IN end position).
At a spindle 1 side screen, press the function selection key
(SYSTEM) then press the menu
selection key
[>]
several times, and the
[PMM]
soft-key is displayed.
Press the
[PMM]
soft-key and then the
[POS]
soft-key, and the screen displays the coordinate
values of the present parts catcher position. Check the displayed coordinate values.
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in one of the positions
indicated below.
(ON)
(PANEL/EDIT)
4)
Press the HEAD CHANGE switch
(head 2) to
select the spindle 2 side.
5)
Select the MDI mode (
) with the MODE
selection switch.
SYSTEM
DOOR INTERLOCK
NORMAL
RELEASE
ON
PANEL
/EDIT
OFF
PANEL
2
1
HEAD CHANGE
2
MODE
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
