MANUAL OPERATION B-65
13-5
Store the Clamp Position Data (ZL-153, 203)
The clamp position of the tailstock body is written to the data table (retained if power is turned off)
and is updated automatically as the tailstock is moved.
If the memory area is cleared or joint pin operates erroneously to connect the tailstock and the
saddle 2, it is necessary to set the clamp position data correctly.
The clamp position data must be set correctly. If the setting is incorrect, the tailstock
cannot be connected with the saddle 2 correctly.
13-5-1
Resetting the Clamp Position Data
The procedure to set the clamp position data, for the tailstock, is indicated below.
<Example>
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in the
(ON)
position.
4)
Press the HEAD CHANGE switch
(head 2) to
select turret 2.
NOTE
Tailstock
Clamp position
(coordinate values in the
machine coordinate system)
DOOR INTERLOCK
NORMAL
RELEASE
ON
PANEL
/EDIT
OFF
PANEL
2
1
HEAD CHANGE
2
