A-26 OPERATION PANELS
5-6
Function Switches [FUNCTION]
The FUNCTION switches are used for the following
purposes.
1.
To carry out test cutting in the automatic mode
2.
To check programs in the automatic mode
3.
To use the in-machine tool presetter
1.
Switch operation is impossible with the PANEL key-switch placed in the
(OFF)
position.
2.
The single block switch
, the optional stop switch
, and the block delete
switch
remain set even if the power is turned off.
3.
The NC functions are made valid or invalid either by using the switches or by making
settings on the OPERATION PANEL screen.
Make sure you thoroughly understand the NC functions explained below before carrying out
program checking or test cutting.
This switch is used to temporarily stop axis movement during automatic
operation.
The indicator above the switch is lit while the axis movement is stopped.
When a test cutting or program check is carried out, the operator must be ready
to press this switch immediately if a problem arises.
To restart the automatic operation, press the
(ST) switch again.
Switch
Function
SP
SBK
OSP
BDT
PSM
PST
DRN
FUNCTION
NOTE
