mori seiki NZ-S1500, Operation Manual

Page: 234 / 324

MANUAL OPERATION B-83
17-3 Conditions for Work Rest Manual Operation
The following conditions must be satisfied for work rest manual operation.
Operation Conditions
WORK REST
OUT
•
The machine is not in automatic operation.
•
The MDI mode is selected.
•
The door is closed, or the door interlock function is released.
•
The spindle, spindle 2 (S type), and rotary tool spindle (M type) are not
being rotated.
•
The lower turret is positioned where it will not interfere with the work
rest.
•
The servo-controlled tailstock is positioned where it will not interfere
with the work rest. (Servo-controlled tailstock specification)
•
The steady rest base is in the IN state. (Tailstock specification)
•
The tool presetter is in the IN state. (Tool presetter specification)
WORK REST
IN
•
The machine is not in automatic operation.
•
The MDI mode is selected.
•
The door is closed, or the door interlock function is released.
•
The spindle, spindle 2 (S type), and rotary tool spindle (M type) are not
being rotated.
WORK REST
FORWARD
•
The machine is not in automatic operation.
•
The MDI mode is selected.
•
The door is closed, or the door interlock function is released.
•
The lower turret is positioned where it will not interfere with the work
rest.
•
The tool presetter is in the IN state. (Tool presetter specification)
•
The servo-controlled tailstock is positioned where it will not interfere
with the work rest. (Servo-controlled tailstock specification)
•
When the work rest is in the OUT state, the spindle, spindle 2 (S type),
and rotary tool spindle (M type) are not being rotated.
•
When the work rest is in the OUT state, the tailstock center IN
operation has been completed.
•
When the work rest is in the OUT state, the chuck and the chuck 2 (S
type) are unclamped.
•
When the work rest is in the OUT state, the steady rest base is in the
IN state. (Steady rest specification)