mori seiki NZ-S1500, Operation Manual

Page: 123 / 324

OPERATION PANELS A-39
5-9-1 Spindle Speed Setting Switches
The spindle speed setting switches are used to set a
spindle speed.
In the manual mode, a spindle speed is set as a ratio
(percentage) in reference to the maximum spindle speed.
In the automatic mode, a spindle speed is set in the range
of 50% to 120% of the programmed speed (100%).
Setting is possible in increments of 10%.
The set value is indicated in the spindle override display
area.
Page A-40 (5-9-2)
<In the manual mode>
1. Spindle speed setting switch (increase)
•
Each press and release increases the spindle speed by 1%.
•
Holding the switch down increases the spindle speed continuously in 2% increments.
•
Pressing the (STOP) switch simultaneously with this switch sets the spindle
speed to 100%.
2. Spindle speed setting switch (decrease)
•
Each press and release decreases the spindle speed by 1%.
•
Holding the switch down decreases the spindle speed continuously in 2% decrements.
•
Pressing the (STOP) switch simultaneously with this switch sets the spindle
speed to 1%.
In the manual mode, a spindle speed is set as a ratio (percentage) in reference to the
maximum spindle speed.
The spindle speed does not exceed the maximum allowable spindle speed.
<In the automatic mode>
1. Spindle speed setting switch (increase)
•
Each press and release increases the override data by 10%.
•
Holding the switch down increases the override data continuously in 10% increments
up to a maximum of 120%.
2. Spindle speed setting switch (decrease)
•
Each press and release decreases the override data by 10%.
•
Holding the switch down decreases the override data continuously in 10% decrements
down to a minimum of 50%.
NOR SPJ REV
STOP
NOTE