A-22 OPERATION PANELS
5-5
Automatic Operation Switches [CYCLE]
The CYCLE switches are used to start an automatic
operation and stop the axis movement temporarily.
1.
The operation is impossible with the PANEL
key-switch placed in the
(PANEL/EDIT)
position.
2.
Close the front door before pressing the
(START) switch.
Switch
Function
This switch is used to start an automatic operation in the memory, MDI or tape
mode.
The indicator in the switch is lit during automatic operation.
The automatic operation start signal is output when this switch is
released after being pressed. Accordingly, automatic operation will not
start while the switch is held down.
Be aware that the machine will start automatic operation if the
(START) switch is pressed by mistake while the conditions
required to start automatic operation are satisfied and an
automatic mode is selected. If this switch is pressed
carelessly, automatic operation will start unexpectedly, and this
could cause accidents involving serious injuries or damage to
the machine.
For the condition for starting automatic operation, refer to
page E-1 (1).
This switch is used to temporarily stop axis movement during automatic
operation.
The indicator in the switch is lit while the axis movement is stopped.
When a test cutting or program check is carried out, the operator must be ready
to press this switch immediately if a problem arises.
To restart the automatic operation, press the
(START) switch again.
CYCLE
START
STOP
NOTE
START
NOTE
WARNING
STOP
