mori seiki NL1500/500, Maintenance Manual, Page: 214 / 245

ӏࡾጀ࣊ȟҋȽȗȻȠ
WHEN SUB-STANDARD MACHINING OCCURS
214
12)
ɀȫ
5
Ȟ੔ɥ՘ɝ۶ȪǾɿʓʵϫᬂɵʚ˂ɥ՘ɝ۶Ȭǿ
12)
Remove the 5 screws and remove the saddle side cover.
13)
ҏ࿎իɁҰᬂɵʚ˂ɥِްȪȹȗɞфᜏሰ͇Ƞʦʵʒ
6
Ȟ
੔ɥ՘ɝ۶ȪǾҰᬂɵʚ˂ɥ՘ɝ۶Ȭǿ
13)
Remove the 6 hexagon socket head cap screws securing
the turret front cover and remove the turret front cover.
14)
ҏ࿎իɁϫᬂɵʚ˂ɥِްȪȹȗɞфᜏሰ͇Ƞʦʵʒ
9
Ȟ
੔ᴥ
NL3000
ᴷ
4
Ȟ੔ᴦɥ՘ɝ۶ȪǾϫᬂɵʚ˂ɥ՘ɝ۶
Ȭǿ
14)
Remove the 9 hexagon socket head cap screws (NL3000:
u
4) securing the turret side cover and remove the turret
side cover.
15)
ɵʍʡʴʽɺɥِްȪȹȗɞфᜏሰ͇Ƞʦʵʒ
10
Ȟ੔ɥ
ᝩ୥ȺȠɞሌ࣊Ⱦ፿ɔɞǿ
15)
Loosen the 10 hexagon socket head cap screws securing
the coupling sufficiently to enable adjustment.
16)
ϡᓸʞʽɥᛷȶȹȗɞڋɔಃɥ՘ɝ۶Ȭǿ
16)
Remove plug covering the eccentric pin.
17)
ൡಽ᫖ໃɥੵоȬɞǿ
17)
Turn ON the main power.
18)
фᜏʶʽʋȺϡᓸʞʽɥوȪǾਖ਼ᬲ
8)
Ɂȭɟᦀᴥ
B
Ȼ
D
ɁࢃɁԡґᴦɥ
“0”
ȾȽɞɛșȾᝩ୥Ȭɞǿ
18)
Using a hex wrench, rotate the eccentric pin to adjust
alignment until the deviation recorded in step
8)
(half the
difference in values B and D) is “0”.
Saddle Side Cover
Z-Axis Protector
ɿʓʵϫᬂɵʚ˂
Z
ᢉʡʷʐɹʉ
Turret Side Cover
Turret Front Cover
ҏ࿎իϫᬂɵʚ˂
ҏ࿎իҰᬂɵʚ˂