Morgana DocuMaster MFC, Service Manual

Page: 71 / 268

Morgana DocuMaster MFC - Service Manual 63
4. Service Procedures - Machine Adjustments and Calibration
4
The bin address procedure forces the CPU to write an identification address to each of
the feed bin control PCBs. When a PCB has been addressed it will keep that address,
even if it is removed and installed on a different feed bin.
Step Action Information
1 Turn on the MFC.
2 Select the
SERVICE
access level. (See Section 4.5.23).
3 Open the
SERVICE OPTIONS
page. Touch the
SERVICE OPTIONS
tab.
4 Touch the
BIN ADDRESSING
button. The MFC will prepare to write to the
bin control PCBs. When it is ready
BIN
1 will be displayed on the
BIN
ADDRESSING
button.
5 Press the red button on the feed
bin control switch on feed bin 1.
BIN
2 will be displayed on the
BIN
ADDRESSING
button.
6 Press the red button on the feed
bin control switch on feed bin 2. Continue this process until you have
addressed all the feed bins.
7 Touch the
BIN ADDRESSING
button
and wait for it to display
DONE
.
8 Return to the
BASIC
page and turn
the MFC off and on.
Note: If a bin or bins fail to address, turn off the MFC and start
the address procedure again.
4.5.6 Initialise the Feed Bin Control PCBs
Each of the feed bin control PCBs, and the gathering area base control PCB, have IC
control chip that uses a basic operating f/w to function. When you initialise the bins, the
GUI CPU checks that the f/w versions of the ICs are up-to-date and correctly
configured. The control s/w will automatically update the f/w if necessary.
Step Action Information
1 Set the main input switch to the ON
(I) position.
2 Select the
SERVICE
access level. (See Section 4.5.23.1).
3 Open the
SERVICE OPTIONS
page. Touch the
SERVICE OPTIONS
tab.
4 Touch the
INITIALISE BINS
button. The MFC will automatically do a
check to make sure if initialisation is
necessary.
5 Wait until the
INITIALISE BINS
button
indicates
NONE
or
DONE
.
•
NONE
shows that no initialisation
was necessary.
•
DONE
shows that the MFC has
initialised the bins and is
finished.
6 Return to the
BASIC
page and turn
the MFC off and on.