23
1
The
Crease Tilt Knobs allow the user to get a perfectly perpendicular crease on the paper.
User adjustment might be needed if crease positions are not perpendicular.
Setting the Crease Tilt Knobs
1
From the GUI, select a two-crease
custom fold, check that blade 1
makes the first crease and that
blade 2 makes the second crease
(see section 2) and load paper.
2
Run a test sheet (see section 2).
3
If one or both the creases are not in
the correct position (see figure 1),
adjustment is needed.
AutoCreaser Pro 385 Knob Adjustment Procedure - Blades 1 and 2
Feed direction
Blade 1
Blade 2
figure 1
NOTE:
Wrong crease positions are
marked in red, correct crease
positions are marked in green.
Blade 1 knob
Blade 2 knob
4
Rotate the knobs counterclockwise
to loosen them.
5
Move the knob(s) slightly, either to
the left or to the right depending
on whether the crease is tilted
either to the right or to the left.
6
Rotate the knobs clockwise to
secure them.
7
Run a test sheet to check if the
creases are now perpendicular.
8
Repeat steps 4 to 7 if necessay.
