7
Rev. 1.0
7/31/2019
SSDC-R/C/IP Hardware Manual
2.1 Installing Software
StepSERVO Quick Tuner is the PC based software application used to configure, and perform servo tuning, drive testing and
evaluation of the StepSERVO products. System servo control gains, drive functionality and I/O configuration are set with
StepSERVO Quick Tuner. It also contains an oscilloscope function to help set the servo control gains.
• Download the StepSERVO Quick Tuner from the Applied Motion Products website and install it.
• Launch the software by clicking Start-----Programs ----Applied Motion Products connect the drive to PC by
communication cable, configure the network on PC. Please see the section below entitled “Connecting the Drive to Your
PC”.
• Connect the drive to the Power Supply.
• Connect the motor to the drive.
• Power up the drive.
• Click the ‘connect’ bottom, the software will recognize your drive, display the model and firmware version and be ready
for action.
The connectors and other points of interest are below:
SSDC-R, RS485 Communication type / SSDC-C, CANopen Communication type
