Mooney 33-0001, Service And Maintenance Manual

Page: 171 / 1047

MOONEY INTERNATIONAL CORPORATION
M20V SERVICE AND MAINTENANCE MANUAL
Page
Date
8
Rev Date
MAR 2017
(see Figure 22- 3). Ensure control rod ends are prop-
erly engaged through witness holes in rod. Refer to
Chapter 27- 10- 00 for Aileron Rigging.
58
_
(

2
_
)
REF: FLOOR
ROLL
ROLL SERVO
CONTROL
SERVO MOUNT
AILERON
CONTROL ROD
ROD
ARM
AILERON RIG
PIN
ROLL SERVO CONTROL ROD ALIGNMENT
FIGURE 22- 3
E.
Install the safety wire (MS20995-C) to (6)
mounting screws in the servo mount arm.
-NOTE-
REFER TO INSTALLATION STANDARD PRACTIC-
ES, GARMIN DOCUMENT 001- 00029- 00 FOR ALL
FASTENER TORQUES EXCEPT AS NOTED.
F.
Visually inspect the connectors to ensure
there are no bent or damaged pins. Repair any dam-
age, and connect pigtail connector. Tie wrap pigtail
to existing harness under control panel.
G. Remove aileron rig pin.
H. Operate all controls through full travel and en-
sure that no binding or restriction occurs. Maintain a
0.10” minimum clearance between push rod and
structure through full range of motion.
I. Configure software (if required) and test per
the G1000 Line Maintenance and Configuration
Manual (#190- 00303- 04 Rev F and or later FAA ap-
proved revision) for more detailed information.
J.
Install center console panels and belly fairing.
22-10-02 PITCH TRIM SERVO AND SERVO
MOUNT
1. Removal of Pitch Trim Servo P/N 011-00878-20
A. Ensure aircraft power is off. Unplug any auxil-
iary power supplies.
B. Set the elevators in neutral position.
C.
Remove LH and RH Tailcone access panels,
and locate GFC700 Pitch Servo Mount.
D. Disconnect servo pigtail connector.
E.
Remove the (2) mounting bolts from Pitch
Trim Servo to Servo Mount.
F. Remove the unit.
-CAUTION-
USE CARE WHEN REMOVING SERVO
MOUNT FROM AIRCRAFT NOT TO ALLOW
ANY FOREIGN OBJECT DEBRIS TO ENTER
SERVO MOUNT ORIFICES (CLUTCH ASSY).
SERVO MOUNT
PITCH TRIM
PITCH TRIM
SERVO
PITCH TRIM SERVO AND MOUNT
FIGURE 22- 4
G. Remove excess grease build- up from the
single servo output gear using a lint- free cloth.
-NOTE-
It is not necessary to remove all of the grease
from the output gear, only the excess grease. DO
NOT USE SOLVENTS TO CLEAN THE OUTPUT
GEAR.
2. Removal of Pitch Trim Servo Mount
P/N 011-01904-00
A. Loosen servo bracket (4) mounting bolts to re-
lease chain tension and remove chain from servo
22-10-02