Moomba Craz, Owner'S Manual

Page: 21 / 72

21
© 2016 Skier’s Choice, Inc.
M
aXIMUM
C
aPaCITIes
In compliance with United States Coast Guard Regulations,
Moomba Boats meet or exceed all safety standards designed for
recreational boats. To ensure safe handling and performance,
each Moomba boat displays a maximum capacity sticker
(see sample), stating the maximum passenger weight load
allowable.
NOTE: Refer to the Maximum Capacity Sticker on your boat
for allowable loading.
Do not exceed the maximum capacity of the boat.
C
oasT
g
UaRD
R
egUlaTIons
The United States Coast Guard boating regulations prescribe
minimum standards of safety to be met and maintained by all
watercraft. It is necessary that your boat remain in compliance
with these regulations.
The staff at Skier’s Choice, Inc. recommend that all boat operators
complete a Coast Guard approved boating safety course.
Your Moomba boat cover is made from the finest canvas and
webbing to ensure that your boat will be protected in the off
season. The cover has been designed to fit securely around each
boat. If your new cover does not seem to be snug, a shrinkage
allowance has been sized in.
Use the following procedure when covering the boat:
• Be sure that the cover fits snugly at the bow then unfold
from front to back.
• Be sure to install cover pole(s) and adjust to proper height,
using set screw on pole(s). This will keep water from
gathering in the center, which can damage the cover.
• Secure all fastening straps around the trailer frame.
• Pull the draw cord equally from both sides and tie off to the
lifting eyes on the stern in accordance with the illustration.
Folding Cover
When folding the cover for storage, be sure the cover is dry. Take
care not to scratch the canvas finish against rough surfaces.
Store in a dry location.
Cover Repair
If the cover becomes damaged, immediately patch and reseal
the area. Use a tent seam sealer to reseal any new stitches.
Spray fabric guard on scraped or worn surfaces. Canvas tears
should be repaired professionally and stitches sealed to prevent
leakage.
Your mooring cover is not designed for trailering. Trailering
with your cover installed may cause premature cover failure
and boat damage. This damage is not warrantable.
C
anVas
C
oVeR