Moog Animatics Industrial Ethernet Cables
Moog Animatics Industrial Ethernet Cables
The following Industrial Ethernet cables are available from Moog Animatics.
M-style to M-style Ethernet Cable
This cable has M12 male threaded connectors at both ends. It is available in 1, 3, 5 and 10
meter lengths. For the standard cable, use part number CBLIP-ETH-MM-xM, where "x"
denotes the cable length. A right-angle version is also available; use part number
CBLIP-ETH-MM-xMRA.
M-style to RJ45 Ethernet Cable
This cable has an M12 male threaded connector at one end, and an RJ45 male connector at the
opposite end. It is available in 1, 3, 5 and 10 meter lengths. For the standard cable, use part
number CBLIP-ETH-MRJ-xM, where "x" denotes the cable length. A right-angle version is also
available; use part number CBLIP-ETH-MRJ-xMRA.
EtherNet/IP Custom Cable
The following figure provides details for creating a custom shielded EtherNet/IP cable.
NOTE:
The motor end of the cable requires an industrial Ethernet connector.
Industrial Ethernet Connector
(Motor end of cable)
PIN
1
2
3
4
+TX
+RX
-TX
-RX
DESCRIPTION
Shield tied to motor housing
RJ45S Connector
(EtherNet/IP master end of cable)
1
2
3
4
5
6
7
8
+TX
-TX
+RX
No Connection
No Connection
-RX
No Connection
No Connection
PIN
DESCRIPTION
Shield tied to RJ45S connector
Moog Animatics Class 6 EtherNet/IP Guide, Rev. B
Page 27 of 160
