11.6.40.2 Error 43-1 (emergency code 6100h)
Cause: Plausibility error between IP adress and subnetmask, subnetmask was
corrected!
Suggested steps:
Check the settings of the IP address and the subnetmask of the Ethernet interface
(X3/X9) in the parameters 671 and 688.
This issue is probably
caused by an unsuitable
parameter setting.
l
Save your parameter set for a later restore.
l
See 'history of parameter changes' and undo
the latest changes.
l
Please check your parameter set for
implausible settings.
l
Please set device to factory setting, restart, and
see if the error occurs again.
l
When reporting this error to your service
partner, please include your device's
parameter setting.
11.6.41 Error 44: Wire break, common error
11.6.41.1 Error 44-1 (emergency code 6100h)
Cause: Motor brake not connected on X13
Suggested steps:
Check motor brake or other device connected on X13, or disable guarding
MOOG
ID No.: CB40859-001 Date: 11/2020
MSD Servo Drive - Device Help
421
11 Alarms & warnings
11.6.42 Error 45: Lock violation error
11.6.42.1 Error 45-0 (emergency code 8612h)
Cause: Unknown lock violate error
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again
The reference value violates
a lock or limit switch.
l
Please check reference values. If this axis is
working in cyclic synchronous mode, make a
scope record.
l
Check factor group settings.
l
Check mode of operation.
This issue is probably
caused by an unsuitable
parameter setting.
l
Save your parameter set for a later restore.
l
See 'history of parameter changes' and undo
the latest changes.
l
Please check your parameter set for
implausible settings.
l
Please set device to factory setting, restart, and
see if the error occurs again.
l
When reporting this error to your service
partner, please include your device's
parameter setting.
