M-style to RJ45 Ethernet Cable
M-style to RJ45 Ethernet Cable
This cable has an M12 male threaded connector at one end, and an RJ45 male connector at the
opposite end. It is available in 1, 3, 5 and 10 meter lengths. For the standard cable, use part
number CBLIP-ETH-MR-xM, where "x" denotes the cable length. A right-angle version is also
available; use part number CBLIP-ETH-MR-xMRA.
Ethernet Cable Schematic
The following figure provides details for creating a custom industrial Ethernet shielded cable.
NOTE:
The motor end of the cable requires an industrial Ethernet connector.
Industrial Ethernet Connector
(Motor end of cable)
PIN
1
2
3
4
+TX
+RX
-TX
-RX
DESCRIPTION
Shield tied to motor housing
RJ45 Connector
(EtherCAT master end of cable)
1
2
3
4
5
6
7
8
+TX
-TX
+RX
No Connection
No Connection
-RX
No Connection
No Connection
PIN
DESCRIPTION
Shield tied to RJ45 connector
Moog Animatics Class 6 SmartMotor™ Installation & Startup Guide, Rev. 03 - PRELIMINARY
Page 36 of 58
Summary of Contents for Class 6 SmartMotor
Page 1: ...Installation Startup Guide Class 6 SmartMotor Technology...
Page 12: ......
Page 20: ......
Page 57: ......
