CASE MOUNTING:
Your new Monsoon Series 2 reservoir features vibration isolation mounting to reduce noise. Although
mounting is essentially the same as mounting any other device in an optical bay, there are a few small
differences.
The goal of vibration isolation is to break any hard mechanical paths between the reservoir and your
case that would normally allow vibration from the pump to be transmitted to the chassis causing
“squeaks”. Start by pressing a compression nut into the back of each silicone rubber mount and then
placing them into the large mounting holes on each side of your reservoir. Be sure to orient them as
shown above.
Slide the reservoir into your case and, if needed, use the temporary mounting holes with the included
M3 x 6mm screws to hold the reservoir in the position you want. Do not tighten these temporary
screws any tighter than needed as they can shift the reservoir left or right if over tightened. Once the
reservoir is where you want it, use the included M3 x 6mm screws and M3 black nylon washers in the
vibration isolation mounting holes being careful not to over tighten. Once you have all four screws in
place for the vibration isolation mounts, you can remove the temporary alignment screws if you used
them.
PAGE 5
Summary of Contents for M2 D5 Premium
Page 1: ......
