11
4.
Once the process is complete, remove the auto-level sensor.
ADJUSTING THE Z-OFFSET
The Z-offset is the distance between the glass build plate and the nozzle. The auto-level
process ensures that this distance is consistent across the build plate, but the distance
itself must be manually calibrated. You can easily do this using a piece of clean, flat
copy/printer paper, which is usually about 100 microns thick. Perform the following steps
to adjust the Z-offset.
1.
Touch
>
.
2.
Place a piece of copy/printer paper on the build plate.
3.
Touch
in the middle of the screen.
4.
Touch
or
to adjust the height of the nozzle up or down.
