25
Click the Configure button, then click Configure Machine to display the following screen.
If the print size is different from the actual size, you can change the display size. Correct
the print size by adjusting the XY values in the Build Size (mm) section. Click Apply
Changes to save your settings.
SLICING WITH CREATION WORKSHOP
Perform the following steps to slice a model using Creation Workshop.
1.
Run the Creation Workshop software program on the included microSD™ card.
2.
Click the
button to load a model file (STL or OBJ).
3.
Click the
button to save the loaded model file in Creation Workshop format.
4.
Click the
button to slice the loaded model file.