19
HARDWARE ASSEMBLY
The Inventor comes pre-assembled and is almost ready to print. All you need to do is to set
the appropriate voltage, mount the extruder set, and install the filament. It will only take
about 5-10 minutes to setup the Inventor and prepare for your first 3D print!
1.
Lay the extruder set on top of the extruder seat with the two extruder fans facing
the front.
2.
Secure the extruder set onto the extruder seat with two M3x12 screws, from the
bottom up.
3.
Use the M2.5 Allen wrench to unscrew the two turbofan bolts.
