33
Control Remote Third Party Device From Local
To control a third party device from local, first determine which HDBaseT™ receiver it is
connected to (1 in the diagram below). Next, use one of the included 3-pin Terminal Blocks
to make a serial cable, plug one end into the RS232 connector on the HDBaseT receiver,
then plug the other end into the serial port on your third party device.
Next, plug one end of the included 3-pin to DB9 RS-232 Cable into the RS232 terminal block
in the position corresponding to the receiver (1 in the diagram below), then plug the other
end into an available serial port on your PC, as shown in the diagram below.
Control Local Third Party Device From Remote
To control a local third party device from one of the HDBaseT™ receivers, first determine
which receiver you will be connecting to (4 in the diagram below). Next, plug one end of
the included 3-pin to DB9 RS-232 Cable into the RS232 connector on the HDBaseT receiver,
then plug the other end into an available serial port on your PC.
Next, use one of the included 3-pin Terminal Blocks to make a serial cable, plug one end
into the RS232 terminal block in the position corresponding to the receiver (4 in the
diagram below), then plug the other end into the serial port on your third party device, as
shown in the diagram below.