15
Connecting a Telephone Paging System
This amplifier provides a 600-ohm balanced input for integrating an external telephone
paging system. Perform the following steps to connect your telephone system.
1.
Lift the bottom of the terminal cover over the TEL PAGING connectors.
2.
Using a flat head or Phillips screwdriver, loosen the T, R, and G screws.
3.
Insert the ground lead from the telephone system under the G screw plate, then
tighten the screw.
4.
Insert the ring lead from the telephone system under the R screw plate, then
tighten the screw.
5.
Insert the tip lead from the telephone system under the T screw plate, then
tighten the screw.
6.
Flip the terminal cover for the TEL PAGING connectors down, then press on the
bottom to click it into place.
7.
For those Zones you want to receive telephone paging broadcasts, slide the
corresponding numbered DIP switch up to the ON position. Slide the other DIP
switches down toward the numbers.
FM Antenna Connection
Perform the following steps to connect a 300-ohm FM antenna.
1.
Lift the bottom of the terminal cover over the TEL PAGING connectors.
2.
Using a flat head or Phillips screwdriver, loosen the FM screw.
3.
Insert the antenna lead under the FM screw plate, then tighten the screw.
4.
Flip the terminal cover for the TEL PAGING connectors down, then press on the
bottom to click it into place.
Summary of Contents for 18802
Page 18: ...18 Sample Connection Diagram ...
Page 19: ...19 Block Diagram ...
