Monogram ZDIC150, Design Manual With Installation Instructions

Page: 7 / 18

Installation Instructions
ADJUST HEIGHT AND LEVEL THE
ICE MAKER
Height adjustments may be necessary to install
the ice maker below a countertop, and may be
accomplished by adjusting both the front and rear
leveling legs. The ice maker must be level to operate
properly.
To level and adjust the height:
1. With one person holding the ice maker, carefully
tilt the machine to access the leveling legs.
2. Use an adjustable wrench to turn the legs.
– Turn legs right to lower, turn left to raise the ice
maker.
3. Check top and side with a level. Continue adjusting
legs until the ice maker is level and stable.
Raise Lower
7
WATER SUPPLY SET-UP
• A cold water supply
with water pressure
between 30 and
120 p.s.i. is required
for ice maker
operation.
•
7RDOORZVXȻFLHQW
ZDWHUÀRZWR
the ice maker, a
minimum 1/2”
diameter home
supply line is recommended.
• Route GE SmartConnect
™
Kit or 1/4” O.D. copper
tubing between house cold water line and the
water connection location.
• The water line should be long enough to extend to
the back of the ice maker when the unit is moved
forward for service.
• Install tubing only in areas where temperatures
will remain above freezing.
• The water line should be flushed to clear any
foreign material before connecting to the ice maker.
NOTE: The only GE approved plastic tubing is supplied
in the GE SmartConnect
™
Refrigerator Tubing kits.
Do not use any other plastic water supply line. The
line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause
water damage to your home. Order parts below at
GEApplianceParts. com or by calling 1.800.626.2002.
GE SmartConnect
™
Refrigerator Tubing Kits are
available in the following lengths:
2’ (0.6 m) WX08X10002
15’ (4.6 m) WX08X10015
6’ (1.8 m) WX08X10006 25’ (7.6 m) WX08X10025
Tools and Parts Needed:
Gather the required tools and parts before starting
installation:
z
Flat-blade screwdriver
z
7/16” and 1/2” open-end wrenches or two
adjustable wrenches
z
1/4” nut driver
z
1/4” (6.35 mm) soft copper or GE SmartConnect
™
tubing
NOTE: Do not use a piercing-type or 3/16” (4.76 mm)
VDGGOHYDOYHZKLFKUHGXFHVZDWHUÀRZDQGFORJV
more easily.