MonLines MWH005B, Mounting Instructions

Page: 1 / 2

EN
Be sure to read the assembly instructions before assembly - installation - commissioning!
This will protect you and prevent damage to your product.
Subject to change without notice
MonLines
Am Marienhof 8
22880 Wedel
Germany E-Mail: info@monlines.
com
Web: www.monlines.
com
Tel.: +49 (0) 4103 / 90387 - 0
Fax: +49 (0) 4103 / 90387 - 11
1. Scope of delivery
Before the actual installation, please observe the following instructions for proper installation:
1. This bracket is designed to be installed and used only as specified in this manual. Improper installation of this product
may cause damage or serious injury.
2. This product should only be installed by a person with manual dexterity and basic knowledge and experience in
assembling.
3. Make sure that the surface on which the bracket is to be mounted can safely support the total load of the unit and all
components connected to it.
4. When mounting the bracket on a wooden stud wall, ensure that the bracket screws are fixed in the centre of the studs.
It is strongly recommended that you use a joist finder.
5. For safety reasons, only lift and position equipment in pairs or with a mechanical lifting device.
6. Tighten bolts firmly, but do not overtighten. Overtightening can damage the components and significantly reduce their
holding power.
7. This product is intended for indoor use only. Outdoor use may result in product failure and personal injury.
2. Assembly preparation
Make sure that you have received all the parts included in the delivery before you start the assembly. If any parts are missing
or defective, please contact your dealer.
MonLines MWH005B
Tiltable TV wall mount
Mounting instructions
Wall plate (1x)
A
linker Haltearm (1x)
B
right supporting arm (1x)
B
M5x14 (4x)
M­A
M6x14 (4x)
M­B
M6x30 (4x)
M­C
M8x30 (4x)
M­D
M8x50 (4x)
M­E
washer (4x),
M­F
small spacer
holder (8x),
M­G
big spacer
holder (4x),
M­H
ST8x50 (6x)
W­A
concrete dowel
(6x), W­B
D8 washer (6x),
W­C
5. Hanging the TV / monitor in the wall plate
Hook the television into the wall plate. Tighten both
screws with a suitable Phillips screwdriver.
Loosen the slider for adjustment, set the desired
inclination and then fix the slider again.
6. Aligning the TV / monitor
Tighten the
screws
Controller
for the
inclination
Screw
left supporting arm (1x)
B