Moneris smartselect, Operating Manual

Page: 167 / 198

SmartSELECT Merchant Operating Manual v 2.0 157
AIR MILES Reward Program
• Select
Wholesale Program Config
to set the parameters for the Wholesale
Program. The
Wholesale Configuration
menu appears.
Configure the Calculator and Factor values
From the Reward Program configuration menu:
a. Select
Calculator 1
. The Calculator 1 keypad appears.
b. Key in the value of Calculator 1 (without the decimal, min. = 0.001, max. =
9,999.999) and press
Enter
. The Reward Program configuration menu
reappears.
c. Select
Factor 1
if you wish to change the displayed value. The Factor 1
keypad appears with the default value (
99
) displayed.
d. Key in the value of Factor 1 (min. = 1, max. = 99) and press
Enter
.
• If the value is less than 99, the Reward Program configuration menu
reappears with the
Calculator 2
and
Factor 2
list items enabled.
• If the value equals 99, the Reward Program configuration menu reap-
pears with the
Calculator 2
and
Factor 2
list items disabled.
e. If you wish to configure Calculator 2 and it is enabled, select
Calculator 2
.
The Calculator 2 keypad appears.
f. Key in the value of Calculator 2 (without the decimal, min. = 0.001, max. =
9,999.999) and press
Enter
. The Reward Program configuration menu
reappears.
g. Select
Factor 2
if you wish to change the displayed value and it is enabled.
The Factor 2 keypad appears with the default value (
99
) displayed.
h. Key in the value of Factor 2 (min. = 1, max. = 99) and press
Enter
. The
Reward Program configuration menu reappears.
Configure the Incentive values:
a. Select
Incentive
if you wish to change the displayed value. The Incentive
keypad appears with the default value (
1.00
) displayed.
b. Key in the value of the Incentive (min. = 0.01, max. = 99.99) and press
Enter
.
• If the value not equal to 1.00, the Reward Program configuration
menu reappears with the
Incentive Start Date
and
Incentive End
Date
list items enabled.
• If the value equals 1.00, the Reward Program configuration menu
reappears with the
Incentive Start Date
and
Incentive End Date
list
items disabled.
c. Select
Incentive Start Date
if you wish to change the displayed value. The
Incentive Start Date (YY)MMDD keypad appears.
d. Key in the 6-character value for the first day the Incentive will be applied
and press
Enter
. The Reward Program configuration menu reappears.
e. Select
Incentive End Date
if you wish to change the displayed value. The
Incentive End Date (YY)MMDD keypad appears.
f. Key in the 6-character value for the last day the Incentive will be applied
and press
Enter
. The Reward Program configuration menu reappears.