Moneris Go®: Setting up Your Terminal
3
Hardware setup
Install the receipt paper
1.
Place the terminal face-down on a clean, dry, flat surface.
2.
Lift the printer latch up to release the printer cover, then pull the
cover back to expose the paper compartment.
3.
Insert the receipt paper roll into the paper compartment with the
loose end unrolling from the bottom of the roll and away from
the terminal.
4.
Unroll enough paper to extend at least one inch (2.5 cm) past the
top of the printer cover.
Note:
If the paper is installed backward, your printouts will be
blank.
5.
Close the printer cover, and press down to snap it back into place
so that the extended paper is held securely.
6.
Turn the terminal over so that the screen is once again facing up.
You are ready to print receipts and reports.
