6
Installation and Operating Instructions Ahti & Ukko
Heater assembly
1) The package includes the heater, heater
blocks (a) and small heater stones (b).
Unpack the components with the box placed
horizontally (see Figures 3.1 and 3.2).
Inspect the heater components visually. If
you notice any discrepancies or deficiencies,
please contact the store where you purchased
the heater. Do not expose soapstone parts to
blows and denting when taking them out of
the package. The sauna’s floor surface should
also be properly protected before you begin
the installation.
2) Attach the heater to the wall with screws.
Observe the safety distances between the
heater and any inflammable material in
accordance with Table 4.4 (see Figure 3.3)
when installing the heater.
3) Install the heater blocks by aligning the
grooves on their sides with the rails on the
inside of the heater sides and lowering the
blocks carefully into place (see Figure 3.4).
The bevelled block should be placed topmost,
with the bevel facing up.
Ensure that there is
a gap between the resistors and the heater
blocks
(see Figure 3.5). If the bottom end of
any of the blocks is straight, place this block
at the bottom.
NOTE! Remove all plastic film before using
the heater!
3. Heater assembly and installation
Figure 3.1
Figure 3.2
a
b
Figure 3.4
Figure 3.3
Figure 3.5