3
3.0 QUICK START GUIDE
Note:
Refer to Figure 1 for switch and button locations.
3.1
Slide Power switch (8) to “On”.
3.2
Rotate Sensitivity Adjust knob (7) fully counterclockwise to
the “Auto” position.
3.3
Aim the laser dot perpendicular to the target - reflective tape,
contrasting color or keyway.
3.4
If the On Target LED (1) is not on, push and hold the Red
Learn/Gain button (6) until the On Target LED (1) blinks
regularly. Note that at higher RPMs the LED will be on solid.
3.5
If after completing step 3.4, the On Target LED (1) blinks
erratically or not at all, rotate the Sensitivity Adjust knob (7)
slowly from 1 to 9 until the LED blinks regularly or is on
solid.
3.6
If after completing steps 3.1-3.5, the On Target LED (1)
blinks erratically or not at all:
3.6.1 Move the sensor closer to the target and ensure it is
perpendicular to the target. Repeat steps 3.1-3.5.
3.6.2 Increase the contrast/reflectivity of the target. Repeat
steps 3.1-3.5.
3.7
Once the On Target signal is obtained, use the Polarity Switch
(5) to select a compatible output pulse for your application.
