8.4 Disclaimer
Do not tamper with your bicycle. Tampering is removing or replacing any original
equipment or modifying your bicycle in anyway that may change its design and/or
operation. Such changes may seriously impair the handling, stability and other aspects
of the bicycle, making it unsafe to ride. Tampering can void the warranty and render your
bike not in compliance with the applicable laws and regulations. To ensure safety, quality
and reliability, use only original parts or Momentum authorized replacements for repair
and replacement. Momentum is not responsible for any direct, incidental or consequential
damages, including, without limitation, damages for personal injury, property damage, or
economic losses due to tampering.
8.5 FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may
cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
INFO:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with radio frequency exposure limits set forth by the FCC for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 5mm
between the device and the user or bystanders.
38
Legal documentation
