Auto Grip Pull Tester
Doc No: TM-638019100
Release Date: 08-10-09
UNCONTROLLED COPY
Page 9 of 20
Revision: E
Revision Date: 03-19-21
Read the following instructions before attempting to operate the Auto Grip Pull Tester.
2.1.
Display Module Operation
See Figure 2-1.
Keypad
1.
Info:
Information: With gauge ON, press and hold Info for
three seconds to view Display Format and Program
Menu.
Setup Menu: With gauge OFF, press and hold Info,
then press ON/OFF to enter Setup Menu. Hold the
Info button until the menu appears.
2.
ON/OFF: Press to turn ON, and hold more than three
seconds to turn off.
3.
ZERO: Press to reset the display or tare attachments.
4.
SEND: Press to send data to a PC.
See Figure 2-2 for controls to navigate menus.
Display
Shows measurement values and other device information.
See section 2.2 for display setup.
Measuring Shaft
Attach any of the included standard attachments or optional
special attachments to measure tension.
USB Connector
Allows for device charging and transfer of data to a PC. See section 2.6 for PC connection.
I/O Connector
RS-232 port for data transmission to an external device. See section 2.6 for external device
connection.
Figure 2-2