Auto Grip Pull Tester
Doc No: TM-638019100
Release Date: 08-10-09
UNCONTROLLED COPY
Page 18 of 20
Revision: E
Revision Date: 03-19-21
3.1 Cleaning
CAUTION: Always disconnect power supply before all maintenance
The Auto Grip Pull Tester maintenance will increase instrument life and produce a consistent crimp
strength measurement capability. The following procedure should be followed at the end of each
operation:
1.
Always disconnect the power supply from this tool when not in use.
2.
For efficient operation, the Auto Grip Pull Tester should be cleaned daily. Use a soft bristle
brush to remove debris from critical areas such as the terminal grip and clamp.
3.2 Calibration
The display module should be calibrated on a regular schedule (usually annually). Molex does not
offer a calibration service for the display module. A local calibration service should be used.