Molecular Devices SkanWasher 300, User Manual

Page: 13 / 78

Installation
SkanWasher 300 User Guide 6
‹
Connect the tubing from the wash buffer (blue) and rinse reser-
voir (green) to the Inlet and Rinse ports on the left side of the
instrument.
Figure 2: Wash and rinse liquid reservoirs
Step 6 Insert microplate lift.
‹
Select the appropriate plate type (round or flat-bottom wells) in
use by selecting the correct printed pattern on the side of the
microplate holder (See Figure 3).
‹
Push the plate holder onto the two rods on the microplate lift until
it snaps in place. (see Figure 4).
!! IMPORTANT: Do not fill the
reservoir bottles completely. Allow
approximately 20% free space for
air pressure.
Waste Reservoir
Vacuum Pump
Washhead
Inlet Rinse
Hyd. Filter
V
acuum
Pressure Rinse Pressure Inlet