Molecular Devices MultiWash+, User Manual

Page: 105 / 152

Chapter 7: Defining a Microplate Type
5032022 C 105
Define the Height for Aspiration
Define the height of the manifold during aspiration for the microplate type.
Figure 7-35: Aspiration height
You can define the aspiration height by editing the offset value, or by using the "teach-in"
method.
Figure 7-36: The Aspiration Height prompt
Button Action
On the left
Press this button to end the process and return to Define Plate without saving any
changes. See Defining a Microplate Type on page 77 .
On the right
Press this button to move the microplate to the currently saved aspiration position
and switch to "teach-in" mode. See
Teach-In the Center of the Well for Aspiration on
page 86 .
Press this button to increase the offset value by 0.1 mm to a maximum of 18.8 mm.
Press this button to decrease the offset value by 0.1 mm to a minimum of 0.0 mm.
Press this button to accept the displayed offset value and then define the dispense
position. See
Define the Dispense Position on page 89 .
Table 7-27: Actions of Control Panel Buttons