2.6 Connecting the Cables
2.6 Connecting the Cables
After the instrument is assembled and the computer is set up, proceed to connect the
power cords and computer cables.
Caution:
Make sure that all assembly is completed before connecting power cord.
FLEXstation
™
100-240V~ 5A 50-60 Hz T6.3 AH
s/n FS 01001
C
NRTL/C
LR88026
"PATENTS PENDING"
US
Parallel Port
(not currently in use)
RS-232 Serial Port
Power Cord Receptacle
RS-232 Serial Cable
Power Cord
Fuse Box Cover
Power Switch
Power Cord Locations
1
Locate the instrument power cord (P/N 4400-0002) and the computer serial cable (P/N
9000-0149) in the FlexStation II accessories box.
2
Insert the 8-pin DIN round end of the serial cable into the RS-232 serial port receptacle
on the back panel of the instrument. Attach the other end to the COM serial port on the
back of the computer.
3
Insert the female end of the power cord into the power receptacle at the rear of the
instrument.
4
Connect the instrument power cord a grounded power outlet of the appropriate voltage.
Molecular Devices recommends that you use a surge protector between the power cord
and the grounded power outlet.
5
Connect the computer hardware power cords to similarly grounded power outlets.
Caution:
Be sure no cables run beneath the instrument. Leave at least three inches
between the back of the instrument and the nearest objects or surfaces to ensure proper
ventilation and cooling.
FlexStation II Operator’s Manual – Rev. D
41
Summary of Contents for FlexStation II
