Mold-Masters Hot Runner, User Manual, Page: 211 / 319

15.14 Torque Settings
CAUTION
Gate seals are to be torqued at ambient (room) temperature and then re-
torqued at processing temperature to the torque value specified. This is to
prevent material leakage from the gate seal.
CAUTION
NOTE
Torque values in the tables should be referenced against the torque values
on the General Assembly drawing for a specific system.
15.14.1 Torque Settings of Dura-Plus Gate Seals
Table 15-4 Torque Settings of Dura-Plus Gate Seals
Product Line Product Size Torque [ft-lb] Torque [N·m]
Dura Plus Deci 25-28 34-38
Hecto 35-40 47-54
Mega 42-48 57-65
15.14.2 Torque Settings of Master-Series Gate Seals
Table 15-5 Torque Settings of Master-Series Gate Seals
Product Line Product Size Torque [ft-lb] Torque [N·m]
Master Series Femto Lite 6-7 8-9
Femto 6-7 8-9
Pico 12-13 16-18
Centi 20-22 27-30
Deci 25-28 34-38
Hecto 35-40 47-54
Master-Series
Melt Disk
Centi 10-11 14-15
15.14.3 Torque Settings of Summit-Series Gate Seals
Table 15-6 Torque Settings of Summit-Series Gate Seals
Product Line Product Size Torque [ft-lb] Torque [N·m]
Summit Series Femto 6-7 8-9
Pico 12-13 16-18
Centi 20-22 27-30
15-24
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MAINTENANCE
Hot Runner User Manual