7. Remove any rust inhibiting material that may be on the four machined
surfaces of the horizontal and vertical beam interface. Apply a light
coating of oil on these four surfaces.
Figure 11-3 Forward sling attachment
Figure 11-4 Rear sling attachment
11.5 Inspection
1. Check that the E-Multi injection unit and the E-Multi Radial have not been
damaged in transit.
2. Check all wires and cables. Ensure they are not kinked or damaged and
are still connected properly.
3.
Check for oil leaks on the machine. If visible, find the source of the leak
and correct. Check oil level. See “Check the Oil Bath Level” on page
Figure 11-5
Oil fill kit (optional)
Unpacking - continued
11-4
E-Multi User Manual
E-MULTI RADIAL OPTION
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.