Mohawk V-035-A-X, Operation And Maintenance Manual

Page: 47 / 112

MV-A00000920 MOHAWK V-A SERIES: VERTICAL RISE DRIVE-ON MANUAL 35,000 - 64,000 LB MODEL 5-1
5. USE
Adressees:
-
USER/OWNER;
-
SPECIALISED TECHNICIAN/EMPLOYER.
5.1. Operation commands
The locks remain opened during the lowering
I SYSTEM MAIN SWITCH
Activating this switch, the control panel in enable.
PS TABLE UP BUTTON
Activating this switch, the vehicle lift begins
lifting.
PDA
PDB TABLE DOWN BUTTON:
1 By pressing the button PDA , the lift:
a) Rises a little bit in order to unlock the mechanical
locks.
b) Starts the lowering.
c) Stops when the platform height is about 500 mm
from the ground.
Press together the buttons PDA e PDB in order to end the
last lowering phase ; the buzzer sounds (BZ).
PEFT
CUT-OFF KEY SWITCH PHOTOCELLS:
the tables are provided with photocells to check platform
synchronisation positioned at the front and rear platform
ends. If there is a difference in height of more than 50 mm,
the photocells interrupt the electric circuit that powers the
control unit (24 Volts). Use the PEFT key to exclude the
photocells; in this case, by keeping the PEFT button turned
it is also possible to perform the upstroke (PS) and
downstroke operations (PD).
BZ BUZZER
PL LIGHT SWITCH
R R . . C C . . / /
U
U
.
.
C
C
.
.
SELECTOR REMOTE CONTROL / UNIT
CONTROL
P
P
C
C PLACE IN MECHANICAL SAFETY CONDITIONS BUTTON:
having been raised to the desired height using the button
PS, press the PC button until the lift lowers on the nearest
mechanical safety position
S
S
T
T
O
O
P
P
R
R EMERGENCY BUTTON of REMOTE CONTROL
Activating this switch, the vehicle lift stops.