INSTALLATION &
TECHNICAL INFORMATION
PLEASE READ PRIOR TO INSTALLATION
Website: www.moflash.com Email: [email protected]
APPROVED
AND
CONFORMITIES
TECHNICAL DATA SHEET
The X195 and X197 are suitable for security, process control & general
industrial signalling applications.
These beacons are of the Flashing mode type (single stage alarm) Xenon beacons
(sometimes called strobes) are controlled via a PCB and put out a very brief but bright flash
of white light by ionizing and then discharging a large current through the xenon gas.
The design allows for termination inside the enclosure.
The X197 high power version only allows for internal connection via the M20 rear knockout.
The unit has provision for a Synchronous Mode of operation. This requires a third wire
connection & a remote synchronising module (not supplied).
For Lens colours add: 01 Amber, 02 Red, 03 Blue, 04 Green and 05 Clear
Key Features Include:
• Terminal block excepts up to 2.5mm cable incorporating rising
clamp protectors (1.5mm
2
X197)
• Suitable for conduit box or wall mounting
• 120
0
prime light output above the vertical axis
• Ingress Protection: Weatherproof to IP65
• Flash Rate: X195 - 60 Flashes / minute Nominal
• Flash Rate: X197 - 55 Flashes / minute Nominal
• Operating Temperature Range: -25 + 55
0
c
•
Enclosure Materials: UV Stable Polycarbonate Lens
UV Stable ABS Bases
• AC Supply: 50/60 Hz
Moflash part code S00408 Issue 2
Code No:
Voltage:
Light Source:
Current:
Rating:
X195-02WH-SB-
15-28v Ac/Dc ~
Xenon 5.0 J
310mA
Continuous
X195-02WH-
15-28v Ac/Dc ~
Xenon 5.0 J
310mA
X195-05WH-SB-
180-240v Ac ~
Xenon 5.0 J
110mA
X195-05WH-
180-240v Ac ~
Xenon 5.0 J
110mA
X197-02WH
24v Dc ---
Xenon 10.0 J
650mA
‘ON’ 2 hours
in any 6
---
---
X195 & X197
Deep Base Option
X195 Shallow Base Option
X195 & X197 Series - (Xenon/Strobe)
VISUAL SIGNALLING DEVICES
