Moeller Rapid Link, Switching And Installation System, Page: 23 / 162

01/08 AWB2190-1430GB
Installation of Rapid Link
function modules
19
Addressing on replacement of a faulty slave
When you replace a faulty slave within an existing busbar run,
addressing can be performed directly through the master,
a
section “Automatic addressing” on page 31.
Precondition: The replacement device must have the same ID/IO
code and the address must be 00 (for RA-DI, RA-SP or RA-OP) or
00A (for RA-MO).
Designation of slave addresses
After addressing, the function modules’ slave address can be
entered on the nameplate.
Installation of Rapid Link function modules
The Rapid Link function modules are housed in identical
enclosures with the same attachment method.
• Diameter of fixing holes, 5.5 mm for M5 screws.
• Length of screws > 10 mm; exception: speed control unit, see
chapter 6on page 83.
• Washer with circlip
• Distance between fixing holes 210 mm.
The default mounting position is vertical. Other mounting
positions are possible – see chapter for respective unit.
The dimensions can be found in the appendix on page 147.
Figure 15: Slave address of function modules on nameplate
h Attention!
Observe the notes in the individual chapters of the units.
h
To facilitate a quick replacement of units, do not tie the
units’ power and data cables together with the motor
supply cable or the sensor cables.
Figure 16: General mounting position
h
Attention! !
Please note the section “Information to EMC” on
page 17.
F
30
F
30
F
30
F
30