Moeller Rapid Link, Switching And Installation System, Page: 116 / 162

Speed controller RA-SP
01/08 AWB2190-1430GB
112
Diagnose and status via LEDs
LED Colour Meaning no signal flashes Signal
AS-Interface
®
Power green AS-Interface
®
-voltage missing – applied
AS-Interface
®
Fault red AS-Interface
®
-fault no fault – Communication
error, e.g. slave
has no address.
UV green Auxiliary power 24 V internal or
external for RA-SP-HE… and DIP
pole 8 = 1 missing – applied
FWD green Clockwise not actuated Not actuated on RA-SP-HE…
because:
• light barrier has been reached
in interlocked manual
operation or quick stop
• 400 V supply failed and
returned in manual mode
1)
• 24 V supply failed and
returned with DIP pole 8 = 1
in manual mode
1)
Start Forward
rotating field
REV green Anti-clockwise not actuated Start Reverse
rotating field
– – Automatic, indicated by key-
switch – – –
Motor: red Group error from power module,
thermistor, motor plug not
connected.
In addition, on RA-SP-HE:
• DIP switch position invalid
• Overload/short-circuit I3/I4
no fault – applied
I 3, I4
RA-SP…342/343
RA-SP-HE green external input via M12 socket,
PIN 4 not actuated – actuated
RA-SP-HE red external input via M12 socket,
PIN 2 not actuated – actuated
yellow external input via M12 socket,
PIN 2 + 4 not actuated – actuated
1) Automatic restarting after a 400 V power failure is prevented. To continue manual operation, a Reset command must be issued (set key-switch to OFF).