Moeller LE 4-505-BS1, Hardware And Engineering

Page: 85 / 94

Software development
83
02/98 AWB 27-1314-GB
왘
Switch to configuration mode by choosing
‹Components
➞
Actual ASi-configuration› in the
menu.
왘
Select the AM 1 module EM 2-105-DX1.
왘
Choose ‹Components
➞
ASi-Slave-Status› in
the menu to show the ASi Slave Status window:
Figure 30: ASi Slave Status window
The top of the window shows the current slave
address. You can choose a new station address in
the pop-up list if required. You are only shown ASi
addresses which are unused. The left-hand panel
shows the required slave parameters which are
stored in the permanent configuration. This panel is
shown empty if a permanent configuration is not yet
available. The right-hand panel shows the current
slave parameter settings and lets you set new
parameter values online if required. In this example,
the parameter settings are not important since this
module has no parameters.
For our example program, choose a new station
address of 1. Click Accept to transfer the new
settings to the slave.
H1314G.BK Seite 83 Freitag, 2. Juli 1999 9:02 09