Moeller AWB2700-1426GB, Manual

Page: 52 / 97

Mounting / Dismounting
48
11/01 AWB2700-1426GB
X Position the lower groove on the rear of the first module
onto the lower edge of the mounting rail.
X Push the module upwards until you notice a firm resis-
tance
X Tilt the top of the module away from you and towards the
mounting rail.
Press the Module firmly against the
upper mounting rail until the upper locating hooks lock in
with an audible click; then let go carefully.
X Slide the module as far to the left as possible, closing any
gap between it and the last XI/ON base module.
Correct mounting guarantees a secure connection and the
communication via the XI/ON module bus.
Repeat the steps to if you wish to mount further
XStart modules.
Plugging the Performance Modules
• The appropriate XStart base module must already be
mounted.
h
It is recommended to blow clean the station using
compressed air before plugging the performance modules.
This prevents dust and grains of dirt from contaminating
the plug-in contacts and thereby negatively influencing
the station communications.
a
b
c
d
a d
For Immediate Delivery call KMParts.com at (866) 595-9616