Modena Circolo - ES 10 B, Manual

Page: 19 / 26

English 16
f. If users want to use the water of poly-Routes "see picture below to connect the pipes.

Before determining the position of the screw holes, you have to convince the right side of the
water heater is more than 200 mm from the floor, so that the availability of a place to fix it when
needed.

Method of installation: After selecting the appropriate position, use fitted inflation bolt to tighten
the bolts firmly on the board, and then hanging water heater.

The walls will be installed to be strong; bolts
inflation should be played loudly and firmly
installed. Hanging water heater on a blank
wall is prohibited.

Source outlet must be adopted from the
good quality of the mono-phase tri-pole
which is based on the standard size. And
must be in accordance with which the
ground wires must be installed properly in a
high position and not easily doused by
water. This outlet should be used for the
appropriate water heater.
ES 10A/B, ES 15A/B, ES 30 B
SETTING THE TEMPERATURE

Temperature of the water heater can be adjusted between 10 ° C - 75 ° C. If the ambient
temperature is higher than 10 ° C, the thermostat can be set between ambient temperature and
75 ° C.
FILL THE WATER

Do not turn on the water heater if the tank has not been filled with water. This is to prevent the
process of heating without water and to extend the life of the heating element.

Open the hot water tap, then the cold water tap so that the water can flow into the water heater. If
the water is flowing, turn on the water heater.
ACTIVATING WATER HEATER

By the time the water heater is heated to a specified temperature, the thermostat will turn on /turn
off the heating element automatically so that the water stays warm.
Part 3:
How to Use