EN
OPERATOR'S MANUAL
13
FOOT ADJUSTMENT
Thermo-disinfector Tethys H10 features four adjustable feet allowing to perfectly level it and
compensate for any imperfection of the bearing surface. Feet can be adjusted by simply
screwing or loosening them.
POWER SUPPLY
The electrical system to which the thermo-disinfector will be connected must be suitably
dimensioned according to the electrical characteristics of the device. This information is
shown on the back of the machine.
GENERAL
PRECAUTIONS FOR
INSTALLATION
To ensure a correct operation of the device and/or avoid risk situations, respect the following
warnings:
- Install the thermo-disinfector on a flat and perfectly horizontal surface, work on the
adjustable feet, if necessary.
- Check that the bearing surface is strong enough to support the weight of the device in
operating conditions (about 50 kg);
- Leave adequate room for ventilation all around the thermo-disinfector, in particular in the
rear area.
- Do not install the thermo-disinfector too close to chambers, sinks or similar places,
avoiding contact with water or liquids. This could cause short circuits and/or potentially
dangerous situations for the operator;
- Do not install the thermo-disinfector in excessively humid or poorly ventilated
environments;
- Do not install the machine in environments with flammable and/or explosive gases or
vapours;
- Install the device so that the supply cable is not bent or squeezed.
It must freely run all the way to the electrical outlet.
- Install the device so that the filling/drainage pipes are not bent or squeezed. Place the
pipes so as to avoid drainage water backflow.