Configuration
Language and Date / Time Setup
Language and Date / Time Setup
Language Setup
1. Under Setup function tab, select
Language
to enter the language setting menu.
2. Select the preferred language from the language drop-down list and click
Apply
to save the setting.
3. Otherwise, click
Cancel
to cancel the setting.
Date / Time Setup
The Date / Time setting menu can be found under this path:
Setup
>
System
>
Date / Time
.
1. To set a date, select the correct date from the calendar and click
Apply
to save the setting.
2. To set up time, click on the target position in the time field (hour:minute:second AM/PM).
3. Click buttons
or
or scroll the mouse wheel up / down to adjust the time values.
4. Click
Apply
to save the setting.
Network Setup
Configure the network setup for the NVR to properly function with Ethernet connection. The Network setting
menu can be found in this path:
Setup
>
Network
.
n
Interface
: Users can setup WAN and LAN configuration under this setting menu. Select " eth0 (WAN)"
to enter WAN configuration menu, and select "eth3 (LAN)" to setup the LAN settings.
n
DHCP Setup
: In the WAN configuration menu, the DHCP function allows users to obtain a dynamic IP
address from DHCP (Dynamic Host Configuration Protocol) server when the NVR boots up.
1. For DHCP users, check “Enable DHCP” box and click
Restart
. The IP address, Subnet Mask, Gateway and
DNS settings listed in IPv4 will be retrieved from network servers. DHCP is dynamic that the settings
change from time to time.
2. For Non-DHCP users, uncheck “Enable DHCP” box, and fill out the required values listed in IPv4 by click-
ing on the box next to each item and using the displayed number pad or the USB keyboard. Please
obtain the information from the network service provider.
3. Click
Apply
to save the setting.
Note
For more details regarding LAN configuration, refer to User’s Manual.
10 / 17